Yamaha PC9501N Manual do Proprietário

EN POWER AMPLIFIER Owner’s Manual

10 Air Flow This unit uses a forced cooling system in which air comes in through the front opening and goes out the rear. Rack Mounting If multiple h

11Specifications General Specifications0 dB=0.775 Vrms, Half Power=1/2 Output Power (3 dB below rated power)Specifications and descriptions in this own

12 Block Diagram

13 Dimensions48088456464380 2625 30 370 30 25Unit: mm

14TroubleshootingThe following table lists the main causes of abnormal operation and the corrective measures required as well as the protective circui

PC3301NPC2001N1/8 power is typical of program material with occasional clipping. Refer to these figures for most applications.1/3 power represents prog

C.S.G., Pro Audio Division© 2004 Yamaha Corporation305APTO-D0Printed in JapanYamaha Pro Audio global web sitehttp://www.yamahaproaudio.com/Yamaha Manu

The above warning is located on the top of the unit. Explanation of Graphical Symbols The lightning flash with arrowhead symbol within an equilateral

(5)-2 1/2 PRECAUTIONS PLEASE READ CAREFULLY BEFORE PROCEEDING * Please keep this manual in a safe place for future reference. WARNING Always foll

(5)-2 2/2 • Before connecting the device to other devices, turn off the power for all devices. Before turning the power on or off for all devices,

5 Introduction Thank you for purchasing a Yamaha PC9501N, PC6501N, PC4801N, PC3301N, or PC2001N Series Power Amplifier.The PC Series of power amplifier

6 Controls and Functions Front Panel 1 POWER/STAND-BY switch and indicator This turns the power of the amplifier on/off. When you press the switch t

7 Rear Panel 1 XLR inputs These balanced XLR-3-31 type connectors are used to connect input signals. They are wired pin 1–ground, pin 2–hot (+), an

8 Speaker connections Speakers can be connected to the amplifier as shown below. Note that speaker impedance will vary according to the connection m

9 Connection Using a Euroblock connector 1. If the wire insertion ports are closed, turn the screws on top of the connector counterclockwise to op