Yamaha MC802 Manual do Utilizador Página 1

YAMAHA®AUTHORIZEDPRODUCT MANUALMC-Series Mixing Consoles

VU Meters and METER Assign Switches (AUX1/AUX2/AUX3/CUE)The MC-series mixing console feature three VU meters with built-in LED peak indicators formoni

STEREO Master FadersThe STEREO master faders independently adjust the level of the left and right channel mainstereo program buss signals appearing at

POWER SwitchFlip up to turn power ON, and down to turn power OFF.The VU meter lamps will light when the power is ON.PHANTOM MASTER SwitchTurn this swi

APPLICATION EXAMPLEIn the system shown below the MC1602 is used as the mainconsole in a sound reinforcement system. Three vocal micro-phones, six drum

BLOCK DIAGRAM12

LEVEL DIAGRAMDIMENSION CHART13

SPECIFICATIONSTotal HarmonicDistortionFrequency ResponseLess than 0.1%, 20Hz – 20kHz @ +14dBinto 600 ohms.+1, –3dB, 20Hz – 20kHz @ +4dB into600 ohmsHu

n n INPUT CHARACTERISTICSINPUTPADINPUTINPUT LEVELSSOURCEMAXIMUMGAINSENSITIVITY**CONNECTORIMPEDANCE IMPEDANCERATED LEVELNON CLlPPINGTYPELEVEL–60dB50 ~

YAMAHA®Yamaha Corporation of America6600 Orangethorpe Avenue, P.O. Box 6600, Buena Park, CA 90622-660012/2/96

YAMAHAMC-Series Mixing ConsolesOperating Manual

Congratulations!You are the proud owner of a Yamaha MC-series Mixing Console. Whether youchose the 8, 12 or 16-channel model, your Yamaha mixing conso

PRECAUTIONSPRECAUTIONS1. AVOID EXCESSIVE HEAT, HUMIDITY, DUST ANDVIBRATIONKeep the unit away from locations where it is likely to beexposed to high te

FRONT PANEL CONTROLSFRONT PANEL CONTROLSInput ChannelsPAD SwitchThis switch attenuates the signal applied to the corresponding rear-panel HI-Z or LO-Z

AUX Controls (1,2 & 3)The MC-series mixing consoles have three independent AUX busses which are fed by thecorresponding AUX controls on the input

Channel FaderThis is the main level control for each input channel. It determines the level of the signal sentfrom the corresponding input channel to

Master Control SectionAUX SEND (1, 2 & 3) Controls & CUE SwitchesThese adjust the overall output level of the auxiliary"mixes" set u

Talkback ON SwitchPressing this switch activates the talkback microphone plugged into the talkback mic connector,allowing voice communication from the