Yamaha Soavo-900SW Manual do Proprietário

Soavo-900SWSUBWOOFER SYSTEMUBOWNER’S MANUAL

6 EnThe position of the subwoofer is not so critical because bass sound is not highly directional. For a sonorous sound field, the use of two subwoofe

7 EnSee pages 7 - 8 when your amplifier has subwoofer (line out) terminal(s), or see pages 9 - 11 when your amplifier has no subwoofer (line out) term

8 EnCONNECTIONS Using two subwoofersConnect the “R” side subwoofer terminal of your amplifier to the INPUT 3 ( ) terminal on this unit using a commerc

9 EnCONNECTIONSConnect an amplifier (and front speakers) to this unit using commercially available speaker cables. Refer to the following instructions

10 EnCONNECTIONSWhen your amplifier has one set of front speaker terminalsConnect the speaker terminals of the amplifier to the INPUT 1 terminals of t

11 EnCONNECTIONSWhen your amplifier has two sets of front speaker terminals and both terminals can output sound signals simultaneously• Connect one se

12 EnCONNECTIONSIf this unit or the amplifier makes a hamming noise when connecting to the speaker terminals of your amplifier, connect both of the GN

13 EnBefore using this unit, adjust the volume balance of this unit to obtain the optimum volume and tone balance between the front speakers and this

14 EnUSING THIS UNITYou can store up to 3 sets of your favorite settings (volume, high-cut, phase and B.A.S.S. setting) in this unit. Storing the sett

15 EnUSING THIS UNIT* This function is available only for Yamaha amplifiers that meet the following conditions: – The amplifier was released in 2005 o

i EnIMPORTANT SAFETY INSTRUCTIONS1 Read these instructions.2 Keep these instructions.3 Heed all warnings.4 Follow all instructions.5 Do not use this a

16 EnUSING THIS UNIT Frequency response of this unitThe figures below show the optimum adjustment of each control and the frequency response when this

17 EnIn 1988, Yamaha brought to the speaker systems utilizing YST (Yamaha Active Servo Technology) to give powerful, high quality bass reproduction. T

18 EnRefer to the chart below when this unit does not function properly. If the problem you are experiencing is not listed below or if the instruction

19 EnType ... Advanced Yamaha Active Servo Technology IIDriver ... 25 cm (10”) cone wooferMagnetic shielding type

©2006 All rights reserved.YAMAHA ELECTRONICS CORPORATION, USA 6660 ORANGETHORPE AVE., BUENA PARK, CALIF. 90620, U.S.A.YAMAHA CANADA MUSIC

ii EnWe Want You Listening For A LifetimeYAMAHA and the Electronic Industries Association’s Consumer Electronics Group want you to get the most out of

iii EnThank you for selecting this YAMAHA subwoofer system.Please read the following operating precautions before use. YAMAHA will not be held respons

1 En• VOLTAGE SELECTOR (Asia and General models only)The voltage selector switch on the rear panel of this unit must be set for your local main voltag

2 En◆ High 600 W dynamic power◆ L.F.E input terminal◆ Sleep timer◆ Remote control capability You can make setting changes and adjustments for this uni

3 EnGETTING STARTED Front panel1 Remote control sensorReceives signals from the remote control.2 STANDBY/ON indicatorGreen: Lights up when this unit

4 EnGETTING STARTED Rear panel1 GND terminalSee page 12 for connection information.2 INPUT 3 terminalsSee pages 7 - 8 for connection information.3 INP

5 EnGETTING STARTED Installing the batteries in the remote control1 Press the mark on the battery cover and open the cover.2 Insert the two supplie