Yamaha 02R96 Manual do Utilizador

02R96-v2 Quick Start Guide 1 02R96-v2 Quick Start Guide

ROUTING In this section, the Selected Channel can be routed to any of the 8 Buses, to the Stereo Bus and to a Direct Output. Just press the relevant

PHASE / INSERT Press this DISPLAY ACCESS switch to see Phase and Insert information on the LCD. Phase reverse is only available for input channels.

CHANNEL PAIR If some Stereo input sources are used, such as a Synthesizer or CD player, it could be useful to pair the relevant channels together. T

FADER GROUPS Fader Groups are useful for controlling many faders by just moving one fader. There are 8 Fader Groups available for input channels and

EFFECTS There are 4 Multi-Effects Units inside 02R96. They can be viewed on the LCD by pressing the INTERNAL EFFECTS switch, and then pressing one o

USING AN EFFECT Before an effect can be used properly, it needs to be patched. The default patch (factory setting) has Aux 1-4 patched to the input

2. Check that the Aux 1 Master fader is up to 0dB (that is its default position). 3. Already audio should be seen on the level meters of Effect 1.

SCENE MEMORY There are 99 SCENE MEMORIES available in 02R96. Each Scene stores all the mixing parameters, including all input channel, output chan

SCENE FADE Normally when a Scene is recalled, the Faders move instantly to their stored position. Using the Fade Time function, the faders can be pr

MONITOR In this section of the console, the operator chooses what to listen to, and controls the listening level. 1. The CONTROL ROOM LEVEL adju

Getting Started with a ‘blank’ desk To erase all memories in the desk, and return it to its factory settings, hold the SCENE MEMORY STORE switch whil

02R96-v2 Tips & Short-Cuts Using the ‘SEL’ switches 1. CHANNEL PAIR Hold ‘SEL’ for one channel and press ‘SEL’ for the adjacent channel to mak

4. AUX SOLO To solo an AUX MASTER while still viewing an INPUT FADER LAYER, press the required AUX SELECT switch once to select it, and once again to

3. DCA / VCA FADERS To have DCA (or analog VCA) style Fader Masters, first check the INPUT FADER MASTER box near the top of the FADER GROUP display p

8. Monitoring a Surround Mix from Tape/Disk To directly monitor a previously recorded mix, without using channels on the mixer, first connect the so

Understanding the Rear Panel All the audio connectors are on the rear panel. They include: 1. 16 Mic inputs with XLR and TRS Jack inputs, and TRS

Understanding the Front Panel All the controls are on the front panel, laid out in logical areas: 1. Analog input gain, pad, insert and +48V. 2. F

Controlling Channel Faders There are 4 layers of faders on the 02R96: 1. Input channels 1-24 2. Input channels 25-48 3. Input channels 49-56 + Aux

Changing INPUT PATCH To assign different inputs to the input channels, such as the Slot 4 inputs, follow these steps: 1. press the INPUT PATCH Disp

ENCODER MODE / FADER MODE The encoders above the faders can be used to edit various channel parameters. The most useful ones are Pan and Aux send.

Using the SELECTED CHANNEL controls When a channel is selected, its settings can be seen and controlled in the SELECTED CHANNEL area. The currently

DYNAMICS Each input channel has both a GATE and a COMP. The output channels only have a COMP. When a DYNAMICS switch or encoder is moved, the LCD s