Yamaha MZ360 Manual do Operador descarregar pdf (Página 24)

18 — English

SPARK ARRESTOR

See Figure 26.

Inspect the spark arrestor for breaks or holes. Replace

if necessary. To purchase a replacement spark arrestor

contact RIDGID customer service at 1-866-539-1710.

Use a brush to remove carbon deposits from the spark

arrestor screen as needed.

DRAINING FUEL TANK/CARBURETOR

See Figures 27 - 28.

To help prevent gum deposits in the fuel system, drain the

fuel from the tank and carburetor before storing.

DRAINING THE FUEL TANK

Turn the engine OFF ( O ).

Turn the fuel valve to the OFF position.

Push the fuel valve knob through the generator housing

and pull slightly to the right to allow you to access the

petcock.

Remove the fuel line from the petcock by squeezing the

ends of the retaining clip and sliding the fuel line off.

Install one end of a drain line over the petcock, and place

the other end in a fuel container large enough to catch

the fuel being drained from the tank.

Turn the fuel valve to the ON position.

When the fuel has drained from the tank, close the fuel

valve and reinstall fuel line securely on petcock.

Reinstall fuel valve knob in generator housing. Push for-

ward until knob snaps securely into position.

DRAINING THE CARBURETOR

Turn the engine OFF ( O ).

Turn the fuel valve to the OFF position.

Position a suitable container under the carburetor drain

screw to catch fuel; loosen the screw.

Allow fuel to drain completely into container.

Retighten drain screw.

NOTE: Consult hazardous waste management guidelines in

your area for the proper way to dispose of used fuel.

MAINTENANCE

REPLACING FUEL FILTER

See Figure 29.

Occasionally the fuel filter may become clogged and need

replacing. To purchase a replacement fuel filter contact

RIDGID customer service at 1-866-539-1710.

NOTE: Fuel tank must be empty before replacing fuel filter.

Run unit until tank is empty, if needed, or inspect filter prior

to fill-up.

To replace:

Turn the fuel valve to the OFF position.

Remove the fuel line from both sides of the filter by

squeezing the ends of the retaining clip with pliers.

Slide the fuel line off.

Replace with new fuel filter.

Reinstall fuel lines to new fuel filter.

Turn the fuel valve to the ON position.

CHANGING ENGINE BATTERY CHARGE

CIRCUIT FUSE

See Figure 30.

NOTICE:

Do not use a higher rated fuse other than the

specified amperage. This could cause damage to

the product.

Grip both sides of the plastic fuse holder and twist apart

to reveal the fuse and spring.

Insert new fuse and refasten the fuse holder by pushing

the two sides of the connector together and twisting to

secure.

NOTE: If spring came out of fuse holder when it was

opened, it should also be replaced inside the fuse holder

before securing.

TRANSPORTING

Turn the engine OFF ( O ).

Turn the fuel valve to the OFF position.

Make sure engine and exhaust of unit is cool.

Lower the handle.

Keep unit level while transporting to prevent fuel spillage.

Do not drop or strike unit or place under heavy objects.

1 2 ... 19 20 21 22 23 24 25 26 27 28 29 30 31

Comentários a estes Manuais

Sem comentários

Yamaha MZ360 Manual do Operador Página 24

Comentários a estes Manuais

Manuais e produtos relacionados com Geradores de energia Yamaha MZ360