Yamaha MOX6 Guia de Instalação descarregar pdf (Página 4)

MOX6/MOX8 Editor VST Installation Guide 4

These are basically the same as those of the Cubase series (version 5.1.1 or later) as a host application. Regarding

Mac OS, only Mac OS 10.5 or later is supported. Note that MOX6/MOX8 Extension does not support PowerPC

architectures.

To use the MOX6/MOX8 Editor VST as a VST3 plug-in of the Cubase series, you’ll need to install the following

software programs. Follow the appropriate instructions below corresponding to the software you’re using.

• Yamaha Steinberg USB Driver Version 1.2.0 or later

• MOX6/MOX8 Editor VST

Driver Installation

To operate your Yamaha hardware from your computer via a USB cable, you’ll need to install the Yamaha Steinberg

USB Driver.

The Yamaha Steinberg USB Driver is necessary when transferring Audio/MIDI data back and forth between your

computer’s Cubase series and the MOX6/MOX8.

n MOX6/MOX8 Editor VST cannot be used over a MIDI connection.

n The MOX6/MOX8 Editor VST will transmit/receive the related messages as MIDI messages to/from the MOX6/MOX8 only when the

computer to which Yamaha Steinberg USB driver has been installed is connected directly to the MOX6/MOX8 via USB. Note that the

different connection manner (via MIDI cables, etc.) disables the communication of the Editor related messages. Even if such a

connection is executed, make sure to connect the MOX6/MOX8 directly to the computer via USB.

Minimum System Requirements

Software Installation

Make sure to check the following website for installation and up-to-date news on the Yamaha Steinberg USB Driver.

http://www.yamahasynth.com/downloads/

Cubase

series

USB cable

Driver

Computer

MOX6/MOX8

1 2 3 4 5 6

Sem comentários

Yamaha MOX6 Guia de Instalação Página 4