Yamaha n8 Guia de Instalação descarregar pdf (Página 16)

English

Using multiple devices compatible with Yamaha Steinberg FW Driver

TOOLS for n Version2/Cubase AI 4 Installation Guide

Up to three devices compatible with Yamaha Steinberg FW Driver

can be used simultaneously. By connecting them in daisy-chain

fashion to a computer via IEEE1394 cables, you can upgrade your

music production system simply by adding other devices.

NOTE

· Keep in mind that up to two devices can be connected when the

Sample Rate is set to 88.2 kHz or 96 kHz. Even if you connect an

additional third device, the last recognized device (other than the

device speciﬁed as the Word Clock master) connected to the com-

puter will not be available.

· Even if multiple IEEE1394 interfaces are installed on the computer,

make sure to daisy-chain connect all devices to the jacks of a single

interface. This is necessary since the computer can only recognize

devices connected to a speciﬁc, single IEEE1394 interface jack, and

cannot recognize devices connected to different jacks of different

IEEE1394 interfaces even though they are installed on the same

computer.

When connecting two or three devices compatible with Yamaha

Steinberg FW Driver to a computer, the order of devices displayed

in the DAW (Cubase etc.) will be maintained even if the power is

turned off. The order of devices will be reproduced when turning

on the power of the connected devices. When the same two or

three devices are connected, a unique number (indicated at the

end of the device name) is automatically assigned to each of the

devices, in the order with which the devices are connected. The

number once assigned to a device will be maintained even if it is

disconnected or the power is turned off. If you want to reset the

order of devices displayed in DAW or the number assignment, fol-

low the instructions below.

1 Turn off the power of all the connected devices com-

patible with Yamaha Steinberg FW Driver then discon-

nect all the IEEE1394 cables.

2 Call up the Control Panel of the Yamaha FW Driver

window then click the [General] tab.

3 Click the [Reset Device Number] button at the bottom

right corner of this window.

NOTE

· The [Reset Device Number] button is available only when all the con-

nected devices are turned off. When any device is turned on, this

button is dimmed and cannot be clicked.

4 Daisy-chain connect two or three devices compatible

with Yamaha Steinberg FW Driver to the computer in

the desired order.

5 Turn on the power of the ﬁrst device connected

directly to the computer.

Wait until the tab corresponding to the ﬁrst device

appears on the Control Panel of the Yamaha FW Driver

window, indicating that the computer has actually recog-

nized the ﬁrst device.

6 Turn on the power of the second device that is daisy-

chain connected to the ﬁrst device.

The tab corresponding to the second device appears on

the Control Panel of the Yamaha FW Driver window, indi-

cating that the computer has recognized the second

device. If a third device has been connected to this sec-

ond device, turn the power on in the same manner. As

necessary, set the Word Clock Master to the desired

device.

Using multiple devices compatible with Yamaha Steinberg FW Driver

IEEE1394 terminal

n8/n12

MOTIF XS series

MOTIF-RACK XS

1 2 ... 11 12 13 14 15 16 17 18 19 20 21 22 23 24

Comentários a estes Manuais

Sem comentários

Yamaha n8 Guia de Instalação Página 16

Comentários a estes Manuais

Manuais e produtos relacionados com não Yamaha n8