Yamaha TSX-100 Manual Página 23

  • Descarregar
  • Adicionar aos meus manuais
  • Imprimir
Vista de página 22
21 En
English
ADDITIONAL
INFORMATION
In case of a problem with this unit, check the following list first. If you cannot solve your problem with the suggested
solutions or if your problem is not listed below, turn off and unplug this unit, and consult the nearest authorized Yamaha
dealer or service center.
Troubleshooting
General
Problem Cause Solution
Power turns on but
immediately shuts off.
The power cable may be connected
improperly.
Make sure the power cable is plugged into
the outlet firmly ( P. 6).
This unit may have received a strong
electrical shock such as lightning or
excessive static electricity.
Set this unit to the standby mode, and
disconnect the power cable. Wait about 30
seconds, reconnect the power cable, and
turn on this unit.
The speakers make no sound. The volume may be set to minimum
level.
Adjust the volume level ( P. 8).
The mute function may be on. Cancel the mute function ( P. 8).
The input source may be incorrect. Select the correct input source ( P. 8).
The disc loaded into this unit may not
be compatible.
Use a disc supported by this unit
( P. 24).
Sound suddenly turns off. The sleep timer ( P. 20) may be set. Turn on this unit and play the source
again.
This unit does not operate
properly.
This unit may have received a strong
electrical shock such as lightning or
excessive static electricity, or power
supply may have dropped.
Set this unit to the standby mode, and
disconnect the power cable. Wait about 30
seconds, connect the power cable, and
turn on this unit.
A digital or high-frequency
equipment produces noises.
This unit may be placed close to the
digital or high-frequency equipment.
Place this unit away from the equipment.
The clock setting has been
cleared.
The power to this unit may have been
lost for more than a week.
Plug the power cable into the outlet
firmly, and set the clock again ( P. 7).
Disc playback
Problem Cause Solution
Some button operations do
not work.
The disc loaded into this unit may not
be compatible.
Use a disc supported by this unit
( P. 24).
Playback does not start
immediately after pressing
.
The disc may be dirty. Wipe the disc clean.
The disc loaded into this unit may not
be compatible.
Use a disc supported by this unit
( P. 24).
When this unit was moved from a cold
to warm place, condensation may have
formed on the disc reading lens.
Wait for an hour or two, and try again.
“No Disc” appears in the
display even though a disc is
in the disc slot, or “Disc
Error” appears in the display.
The disc loaded into this unit may not
be compatible.
Remove the disc and then check whether
this unit supports the disc or not
( P. 24).
The disc may be dirty or foreign
substance is stuck on it.
Remove the disc and then wipe the disc
clean or remove the foreign substance.
Disc is loaded upside-down. Remove the disc and then load the disc
with the labeled side facing up.
6
Vista de página 22
1 2 ... 18 19 20 21 22 23 24 25 26 27 28 ... 105 106

Comentários a estes Manuais

Sem comentários