Yamaha DRCX Manual do Utilizador descarregar pdf (Página 45)

CHAPTER2 PROFIBUS Unit

e Point zone judgment method selection

The position judgment parameter is selected when the point

output selection is "2" (point zone output) or "3" (movement

point zone output).

DescriptionValue

OUT valid position

Positioning-completed pulse

MEMO

• The Point zone judgment method selection is supported by

the following controller versions:

ERCX, SRCX : Ver. 13.64 or later DRCX : Ver. 18.64 or later

SRCP, SRCD : Ver. 24.21 or later SRCP30 : Ver. 24.30H or later

• In controller versions prior to the above versions, the "OUT

valid position" is the only point zone judgment method.

Initial value 0

CAUTION

Any value other than the above is handled as a "0" (Type 0).

(Example) If set to 2331, this is handled as a "0" (Type 0).

If set to 10, this is handled as a "0" (Type 0).

Moreover, if Type 2 (Point number output type) or Type 3 (Point teaching type)

is selected in controller versions not supporting the movement point zone output

while the point output selection is specified as "3", this is also processed as a "0"

(Type 0) setting.

(Example) In controller versions not supporting the movement point zone

output:

If set to 331, this is handled as a "0" (Type 0).

1 2 ... 40 41 42 43 44 45 46 47 48 49 50 ... 147 148

Sem comentários

Yamaha DRCX Manual do Utilizador Página 45